The SESAR 3 Joint Undertaking is an institutionalised European partnership between private and public sector partners set up to accelerate through research and innovation the delivery of the Digital European Sky.
Proposals may include other research elements in addition to the proposed research elements below, if justified by their contribution to achieving the expected results of the topic and fully aligned with the development priorities defined in the European ATM Master Plan.
Vertiport management for crewed VCA – EC IR 2014/1111 established the requirements for operations of crewed VCA, with specific requirements for the specification in the operational flight plan of at least two safe landing options at the destination, as well as adequate vertiports, diversion locations for VTOL aircraft (carrying out flights for medical missions in urban areas) (VEMs) operating sites that are available and permit a landing to be executed in a critical failure for performance (CFP). The research must establish how to fulfil this requirement from the ATS perspective, addressing:
The research must address the following cases:
The research must aim at delivering a TRL6 solution aimed at enabling the deployment of crewed VFR VCA and Progress towards a future solution applicable to crewed IFR VCA, for which an FF-ICE flight plan acceptance process must be defined and validated (for this point, coordination with relevant projects in WA1 and WA3 is required).
This element covers vertiport management for vertiports located in controlled airspace (class A-D) – which could also be in U-space airspace – and vertiports located in uncontrolled airspace (class F and G) that is not also declared as U-space airspace. Vertiports located in uncontrolled airspace that is also U-space airspace are covered in the element below (in this same WA).
Note that there is on-going work under project EUREKA.
Advanced vertiport and VCA U-space services – This element covers vertiport management functions and activities that impact traffic management for vertiports located in U-space airspace, bearing in mind the constraints imposed by battery powered aircraft. This may include:
These processes should be identified, and consideration given to their optimisation in the context of U-space including collaborative decision making and coordination as appropriate. Note that there is on-going work under project EUREKA.
This topic covers vertiport management for vertiports in uncontrolled airspace (airspace F and G) that is also declared to be U-space airspace (expected to have significant traffic of small drones); the focus of the research is to ensure separation between small drones and VCA vertiport users. Vertiports that are not located under U-space airspace or that are located in U-space airspace in controlled airspace are covered by the element above (in this same WA). Initially, the scope is focused on crewed VCA operations, but it is expected that the same concepts will be applicable for uncrewed VCA.
Crewed IFR VCA – The aim of the research is to develop the concept for IFR crewed VCA, building on existing SESAR solutions for IFR helicopters “Optimised low-level IFR routes for rotorcraft” (SESAR solution #113) and “Independent rotorcraft operations at airports” (SESAR solution PJ.02-05). The solution should assess the applicability of existing IFR rotorcraft procedures and flight planning processes to VCA, adapting them where necessary. In particular, the research must assess how VCA energy management constraints may affect the capability of VCA aircraft to follow the type of IFR clearances in use for helicopters and develop and validate their use for VCA, proposing and validating new clearances where needed.
Note the flight planning aspects related to the introduction of the landing sites in the FF-ICE flight plan should are linked to vertiport management and hence in scope of the previous bullet point “Vertiport management for crewed VCA”.
Automation of the VCA cockpit and remote pilot’s working position – The objective of this element is to address pilot digital assistance and automation support for the VCA cockpit to support a simplified VCA workload (e.g., aimed at a reduction of VCA crew workload related to pilot’s tasks and tasks related to communication with ATM, implementation of tactical ATC clearances, and on-board implementation of strategic changes to the flight plan in the execution phase for IFR VCA (after an FF-ICE/R2 revision process). The scope includes in particular the development of cockpit automation to support a concept for digital ATM communications via CPDLC during all phases of flight (en-route, TMA and airport).
The ultimate objective is to make it possible that the flight crew workload is reduced to support the concept of one remote pilot overseeing from its working position two or more VCAs.
Note that there is on-going work on this research element under project OPERA.
Automatic take-off and landing (ATOL) for crewed or uncrewed VCA and helicopters – The scope includes the development of navigation and procedures to enable all -weather take-off and landing for crewed or uncrewed VCA. Resilience of the navigation solution must be addressed. The solution is expected to progress from an initial flight-director-based concept towards the end goal of autopilot-based ATOL. Charts, procedure design and avionics should be addressed. Note that similarly to what happens today with Autoland for fixed-wing aircraft today, air traffic aspects e.g. clearance for approach, take-off and landing are not different in ATOL from vs. manual TOL (just like whether Autoland is used does not change the way ATM currently manages a flight), and hence do not need to be covered by this solution.
Note that there is on-going work on this research element under project OPERA.
ATC and flight information service (FIS) automation support – VCA will first be certified as VFR, to later progress to IFR. The objective of the research is to increase the level of automation of VFR aircraft by ATC and FIS. Flight data processing systems (FDPSs) are designed for supporting ATC in the management of IFR aircraft, and typically do not provide adequate functionality to support ATC for the management of VFR aircraft. This results in VFR flights often causing unexpected ATS workload in the lower airspace. Research shall develop ATS automation tools and procedures to provide ATC or FIS services to VFR aircraft in airspace C-G and FIS services to IFR aircraft in uncontrolled airspace (airspace F and G). Research shall aim, as much as possible, at developing tools and concepts that can be applicable to both ATC (TWR or En-Route/TMA) and AFIS. The tools and procedures to be applicable will be applicable for all equipped VFR aircraft (not just VCA):
This research will pave the way for the introduction of digital flight rules, which is currently in scope of exploratory research.
A funding rate of 70% applies to all beneficiaries (regardless of their legal status).
A number of non-EU/non-Associated Countries that are not automatically eligible for funding have made specific provisions for making funding available for their participants in Horizon Europe projects.
Beneficiaries will be subject to the following additional dissemination obligations:
Beneficiaries will be subject to the following additional exploitation obligations:
Beneficiaries must acknowledge these obligations and incorporate them into the proposal, outlining the efforts they will make to meet them.
SESAR 3 JU – Helpdesk: info-call@sesarju.eu